GPM RACING,ROADTECH TIRES&WHEELS SCX-10 HONCHO RTR VENTURE TOYOTA FJ CRUISER KOMODO SAWBACK SCX10 II BRASS PENDULUM WHEEL KNUCKLE AXLE WEIGHT + 23MM HEX ADAPTER -20PC SET GPM023X

Product major function & usage:
To increase the weight of each wheel to stabilize the wheel, enlarge the angle of crawling, especially when the car is digging into some low lying area landspaces, grab the ground firmly and smoothly drive back to level.

Major advantages of upgrading to this product:
This part is designed with a bearing in the middle with a delrin collar, the weight pendulum is made narrower on the top and wider at the bottom to allow you to crawl in different angles. The additional weight is kept downward so the crawler is more grabby to the ground and able to crawl in a larger angle.

Other special notes and comments :
1. Suitable for Traxxas TRX-4. Axial SCX-10 I & II. HPI Venture 116564
2. Suitable for GMADE Sawback / Sawback 4LS / Komodo (The 2pcs of metal washers are for GMADE cars - put underneth the rear shaft hex pins)
3. This part is being installed onto the outer case of the front & rear knuckle arms, specially designed by us that does not exist in the original chassis.
4. The weight of the single pendulum is 128 gram (excluding bearings and collars).
5.5. Two sets of hex wideners are provided. 23mm hex wideners for Traxxas TRX-4 which is 18mm wider than original. 23mm hex wideners for Axial SCX-10 I / SCX-10 II; GMADE Sawback / Sawback 4LS / Komodo. HPI Venture 116564 which is 17mm wider than original.

6. This product needs to be used on wheels with inner diameter 45mm, wheel shaft hole 5mm.
7. To use with TRX 4, insert the white delrin collars on the back side of the pendulum wheel with groove and use the screw pin to stabilize the hex.
8. To use with Axial SCX-10 I & II, GMADE Sawback / Sawback 4LS / Komodo, HPI Venture 116564, insert the bearings on both sides, install hex directly onto the steel pin.